Oqueque, v1.8.1e, is not post raids or any premades..............

Setup tab -> Make sure auto join oQ General is checked.
Find premade tab -> press find mesh button
Type /oq tz sk in your chat area

You must be version 1.8.0 or better. 

I did all of those things and I am still not seeing any premades;;;;;I am running 1.8.1e

What is your connection?

Bottom right hand side of the find premade tab. 

OK, I did the folowing:
Setup tab -> Make sure auto join oQ General is checked.
Find premade tab -> press find mesh button
Type /oq tz sk in your chat area

You must be version 1.8.0 or better.   version = 1.8.1e

Did not work, but................I pressed the "find mesh" button a second time after entering "/oq tz sk" then noticed the "/" was missing so I started to delete the line and Oqueque started working.................not bad for an old hardware engineer......ansi C rules......

Same problem here. 
I have done what was said in the above posts, without luck.
My "connection" says 5 - 0

Any idea ?

Same here. Connections 2-1 
Did all the stuff before but still nothing... Oqueue finds some premates but after some seconds it refreshes itself

Same problem here.
I have done what was said in the above posts, without luck.
My "connection" says 5 - 0

Any idea ?

 

5 - 0 is a really weak connection.

Try using the find mesh button until your second number is higher than 10.

Same here. Connections 2-1 
Did all the stuff before but still nothing... Oqueue finds some premates but after some seconds it refreshes itself

When the groups showup then disapear it means that you have a time issue. By time Issue I mean the clock on your computer is incorrect. Check that your time zone daylight saving time and other time settings are correct in windows. 

i reseted the internettime more than once.

with my main char everything works fine... plenty of connections and ne resets!

an other condition under which groups may disappear would be a lack of data from the mesh.

premade group info pulses from the raid leaders every 30 seconds.  if a group hasn't received information for more then 3 minutes, it is considered 'stale' and the group will be removed.

keep in mind, when users go into an instance, they disconnect from a majority of the mesh traffic.  i do this to minimize any impact on users while in an instance.  when they come out, they reconnect and resume sending data.

if you have a weak connection, your connections may stop relaying if they go into an instance... making your connection even weaker and possibly stop all flow of data.  this is why we do not recommend hitting 'remove now' if you're on an underpopulated realm